![]() Note that most traffic is passing over the default route, while the subnet specified in the command ( 10.10.0.0/14) is passing over the tunnel. Your routes after this command will end up looking something like # ip routeĭefault via 10.1.1.1 dev wlp4s0 proto static metric 600ġ0.1.1.0/24 dev wlp4s0 proto kernel scope link src 10.1.1.50 metric 600ġ0.10.0.0/14 dev tun0 scope link metric 6ġ80.10.34.165 dev tun0 scope link metric 6 Where 10.10.0.0/14 should be the subnet you'd like to have pass through the VPN. Then you'd follow the instructions in this github gist. As the comment in the PKGBUILD says (youve read it, right ) ), Cisco does not provide public downloads for this, so you have to obtain the installer yourself either through your own Cisco account or through your companys. You'd also need vpnc-script in order to make the process of setting up routes a little easier (although you can always manually go back afterwards and use the ip route commands). ![]() If you make use of an alternate client, openconnect, split tunneling is fairly straightforward. But this still does not work for all the VPN gateways. ![]() ![]() Than I entered the URL of the host and got the prompt and progressed through the authentication. I can only address the first part of that question, "would it be possible to setup a linux VM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |